Outboard Motor Test Tank

$2,299.00

SKU: ME-OMTT

The Outboard Motor Test Tank can be used with the ME-110 Large Outboard Stand or the ME-140 Small Outboard Stand. It can be converted into a conventional test tank by installing a wood transom into the interior brackets. Larger outboards may not be able to run at full throttle in this tank. *Please note the ME-OMTT ships on a large skid and must be shipped to a business location with the proper unloading facilities.

Shipping

Shipping Cost: $300.00
Call to check for a lower quote.

Back to: Service Equipment & Stands

Proudly Designed and Manufactured in Zeeland, MI.

We accept Visa, MasterCard, Discover, and American Express

Call our Sales Team: 9am-5pm EST 1-800-305-8117

Most products (unless otherwise stated) are shipped 1-2 business days after an order is placed

For shipping outside of the Continental US please email or call our US based sales staff.

Outboard Motor Test Tank - ME-OMTT

Currently Building Stock, May have 6-8 week lead time.

The ME-110 HC DOES NOT work with the Test Tank. The ME-140AT DOES NOT work with the test tank.

Capacity Use with our ME-110 or ME-140 for clamp on or smaller bolt on outboard motors
Holds 265 gallons of water at the recommended level

Dimensions Length: 60 inches
Width: 47 inches
Height: 41 inches

Weight 450 lbs

Materials Steel
Hot-Dip Galvanized
Comes with: Drain Plug, 2 Rubber Coated Brackets, 2 Pins with Wire Locks

Shipping Please note the shipping quote at checkout is for a continental US business address.
Call our Sales Team at 1-800-305-8117 if you are shipping to a residential address, school, military location, or internationally.

The ME-OMTT is designed to be a great asset for easier testing of outboards. In order to eliminate the need to constantly pick up and move outboards from stand to test tank and back, our tank is designed so the legs of the ME-140 or ME-110 follow channels under the test tank. To use, rotate the motor up into the lock position, roll the stand into the test tank brackets and pin them into place, then rotate the outboard back down into the run position while on the stand. As an example, we have tested a 15 hp motor full throttle in the forward position. You can see that test on You Tube. Larger outboards may not be able to run at full throttle in this tank. Our test tank and stands are designed to work together so that while an outboard is mounted on the stand it never needs to be removed throughout maintenance and testing, saving time and contributing to safety.

The test tank is able to be picked up with a fork truck, while full of water, and moved wherever you need. The entire unit is hot dip galvanized for greater protection from different environments. The test tank comes with a drain plug, 2 rubber coated brackets, and 2 pins with wire locks.

We have also designed the test tank so that you may, if you wish, add a 34" long 2"x8" board into channels welded inside in order to use the tank without having one of our stands.